Applications:  Dynacube™ 2-axis, Dynacube™ Triaxial, Dynacube™-S Triaxial
 

The DYNA-ILC is a three axis ILC unit which provides a DC/DC converter, or a signal conditioning (velocity to acceleration), or amplification of the signal, or a combination of these three functions in a single compact machined aluminum box.  Units can only be configured at the time of manufacture since they are fully encapsulated with special epoxy resins for ruggedness and durability at assembly. Signal conversion and gain options are exclusive;  only one or the other may be specified.  The unit has separate input and output connectors for each of the three sensors plus two connectors for voltage input/velocity output and acceleration output.  

•       As a power converter, the DYNA-ILC will allow the user to supply a single excitation voltage (typically +10 to12 Vdc) and provides a bipolar voltage (±13.2 Vdc) output to the three sensors in the triaxial array.  The order number for an ILC for power conversion has the letter “D” as the ILC first option indicator. (Power converter option not for use with Dynacube-S)
  

•     As a signal conditioner, it will covert the standard angular velocity output of the three sensors to angular acceleration signals. (The calibration data sheet provided with the DYNA-ILC will specify the volts-per-volts output of the acceleration signal at 10 Hz. and at 100 Hz. This is a differential circuit. The gain at 100 Hz. will be ten times that at 10 Hz.) . The order number for an ILC for signal conversion  from velocity to acceleration has the letter “A” as the second ILC option indicator.  All three sensor outputs will be converted unless a custom order is specified.
  

•      As an amplifier, the ILC will supply an amplified signal with gain of 1 to 1000 times normal signal output.  Standard versions are available in 1, 10, 100, or 1000 times gain. The order number for an ILC for signal amplification from 1 to 10x has the letter “G” as the second ILC option indicator.  For gain from 1 to 100x, the letter “H” is specified.  For gain of 1000x, the letter “L” is specified.  (See examples below.)  Note that either gain or acceleration signal output can be supplied, not both.   All three sensor output signals will be amplified at the same amplification rate unless a custom order is specified.

Allowable DYNA-ILC Order Numbers

DYNA-ILC -D DYNA-ILC -A DYNA-ILC -DA DYNA-ILC -G DYNA-ILC -H     DYNA-ILC -L    DYNA-ILC -DG  DYNA-ILC -DH   DYNA-ILC -DL   DYNA-ILC

Power conversion only Signal conversion from velocity to acceleration only Power conversion and Signal conversion from velocity to acceleration Signal amplification of 10x only Signal amplification of 100x only Signal amplification of 1000x only Power conversion and Signal amplification of 10x Power conversion and Signal amplification of 100x only Power conversion and Signal amplification of 1000x only continued.

Cables required with the DYNA-ILC-xx In-line- conditioner:

• CA-05A    SENSOR to DYNA-ILC  Cable 

• CA-03A    DYNA-ILC to test equipment and power supply

• CA-03AX  DYNA-ILC to test equipment for acceleration output option

Check individual sensor order sheets to verify that the specific DYNA-ILC model applies to the specific sensor you are ordering since some limitations apply.  Models Dynacube-S cannot be used with power conversion options.

Note: The CA-03A and CA-03AX cables have AirBorn^® M series connectors at the ILC box and bare ends for the test equipment and power supply connections.  These require direct connection or customer supplied connectors at the test equipment and power supply.